Barbed Wire Topping in Ocala, FL
Three-strand barbed wire on outrigger arms for chain link fencing across Marion County. Added to new fence or existing fence. Angled outward for maximum deterrence. Posts checked and reinforced as needed.
Get a Free Estimate ›The Most Cost-Effective Security Upgrade for an Existing Chain Link Fence
Adding barbed wire topping to an existing chain link fence is one of the most cost-effective security upgrades available. The fence stays in place. Outrigger arms bolt onto the existing posts. Three strands of barbed wire run across the arms at a 45-degree outward angle.
The result is a fence that is much harder to climb over. Anyone attempting to climb over an outward-angled barbed wire topper has to lean away from the fence at the top. Most people stop when they reach the wire.
Fences R Us adds barbed wire topping to new and existing chain link fencing across five Central Florida counties. Existing posts are assessed before installation. Posts that cannot support the added tension are replaced or reinforced before the topping goes on.
Barbed wire topping is part of the Commercial & Chain Link Fencing service. It is often combined with commercial security fencing upgrades on the same perimeter.
Barbed Wire vs Razor Wire Topping
Barbed Wire Topping
Three strands of 12.5-gauge galvanized barbed wire on outrigger arms. The most common security topper on commercial and industrial fence in Marion County. Effective deterrent for most applications. Allowed on commercial and agricultural properties. Not permitted on residential fence in most Ocala zones.
Inward vs Outward Angle
Standard outrigger arms angle outward at 45 degrees. This is the most common configuration and the most effective at deterring climbers approaching from the outside. Inward-angled arms are used on sites where escape prevention (not just entry prevention) is needed. Double-arm configurations angle both ways.
Razor Wire Topping
Razor wire uses barbed tape with sharp edges. More aggressive than barbed wire. Standard on utility substations, fuel depots, and high-security perimeters. Not permitted in residential areas or near public pedestrian access points. Installed in coil on top of the fence with or without outrigger arms.
Vertical Extension Arms
Vertical extension arms add height straight up rather than at an angle. Used where the fence height needs to increase but outward angle is restricted by adjacent property lines. Less effective than angled arms for climbing deterrence but adds height to the barrier.
How Barbed Wire Topping Is Added to an Existing Fence
Adding barbed wire topping is a one-day job on most existing perimeters. The process has three steps.
Every existing post is checked for plumb, concrete depth, and post diameter. Posts that are leaning or corroded are flagged for replacement or reinforcement before the topping is installed.
Outrigger arms bolt to the top of each post using post caps and bolts. Arms are set at the specified angle and tightened. Corner and end posts get heavier-duty arm attachments to handle the wire tension at direction changes.
Three strands of barbed wire run from arm to arm across the full perimeter. Wire is tensioned and tied at each arm. A loose barbed wire strand defeats the purpose of the topper. Fences R Us pulls wire tight on every job.
Service Across Five Central Florida Counties
Fences R Us serves commercial and residential properties within roughly one hour of Ocala.
Other Chain Link Services from Fences R Us
See the full Commercial & Chain Link Fencing page for all available services.
Frequently Asked Questions
Get a Free Estimate
Manny comes out, measures the job, and gives you a written quote. No obligation. Call (352) 266-2849 or use the form below.